Metrology & Measurement Lab

Lab In-charge

Mr.Alagu Sundara Pandian, M.E
Assistant Professor


LIST OF EXPERIMENTS
Introduction to Metrology
1. Measurement of Components using Vernier Caliper
2. Measurement of Components using Vernier Height Gauge.
3. Measurement of Components using Vernier Depth Gauge
4. Measurement of Components using Micrometer
5. Checking the Limits of Dimensional Tolerances using Mechanical Comparator
6. Measurement of Gear Parameters using Gear Tooth Vernier
7. Measurement of Thread Parameter using Profile Projector
8. Measurement of Angle using Vernier Bevel Protractor
9. Measurement of Taper Angle Measurement using Sine Bar and Slip Gauge
10.Measurement of Thread Parameters by using Floating Carriage Micrometer
11.Measurement of Torque using Gauge Load Cell
12.Measurement of Force using Strain Gauge Load Cell
13.Temperature Measurement using Thermocouple
14.Measurement of Straightness and Flatness Using Two Axis Auto Collimator
15.Co ordinate Measuring Machine
16.Surface Finish Measuring Equipment
17.Bore diameter measurement using telescope gauge
18.Parallel/Counter Flow Heat Exchange

BEYOND THE SYLLABUS
1. Checking the Limits of Dimensional Tolerances using Electrical Comparator
2. Checking the Limits of Dimensional Tolerances using Pneumatic Comparator

LIST OF MAJOR EQUIPMENTS

  • Micrometer Vernier Caliper
  • Vernier Height Gauge Vernier depth Gauge  Slip Gauge Set
  • Gear Tooth Vernier
  • Sine Bar
  • Floating Carriage Micrometer
  • Profile Projector
  • Tool Makers Microscope
  • Parallel / counter flow heat exchanger apparatus
  • Mechanical / Electrical / Pneumatic Comparator
  • Autocollimator
  • Temperature Measuring Setup
  • Force Measuring Setup
  • Torque Measuring Setup
  • Coordinate measuring machine
  • Surface finish measuring equipment
  • Bore gauge
  • Telescope gauge